100 Miscellaneous MISC: MPE Code checksum is faulty All The BOOT EPROM monitor detected that the MPE firmware currently stored in the code bank(s) (i.e. Flash memory) is corrupt. The firmware will not be executed when the recorder is reset or powered-up. The code bank(s) must be programmed again. If this error is reported after re-programming, the code bank may be too small for the downloaded file. Check with a firmware programmer. The Flash parts on the MPE may also be faulty, so try a new MPE. Record the error message and call Creo service. The firmware in the code bank was somehow corrupted The MPE's Flash parts are faulty The MPE's code bank is too small for the downloaded file ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:16 2008 PST